APPLICATION:

STEP ONE: Always apply to clean, dry lashes.

STEP TWO: Apply a thin layer of bonder to your lashes and allow to dry for one minute.

STEP THREE: Using tweezers, gently apply cluster to the underside (at the base of natural lashes just above the water line) of natural lashes working from the outside corner in. After all cluster lashes are applied, gently press together with clean, dry fingertips to fuse with your natural lashes.

STEP FOUR: After you are finished applying lashes, brush the sealer onto the top and underside of the lashes. This will help to form a barrier to protect against elements that break down the lash glue.

REMOVAL:

Apply remover to the top side and bottom side of lashes. Bond will dissolve and lashes will easily detach from your natural lashes.

USE THE SEALER TO PROTECT AGAINST:

The natural build-up of oil, dirt, sweat and other pollutants in the air.

Residue that occurs from daily makeup such as eyeliner, eye shadow, etc.

Sweat from exercise and an active lifestyle.

TIPS FOR LONGER WEAR:

Apply a 2nd coat of bonder and wait one minute before applying lashes.

Coat lashes from base to tip with Bonder (this is your glue). Do not use too much; a thin layer is best.

Use the sealer (it's like a top coat to a manicure); you may reapply daily.

Avoid direct moisture to lashes.

Be careful when swimming, showering, washing face, etc. As with all temporary lash systems, the adhesive is not waterproof.

Sleeping on your side or belly or applying pressure to the lashes can interfere with the life of the application.

Press lashes together with clean, dry fingertips every morning to help secure the bond.

Wash your face using our Makeup Removers to avoid exposure to moisture.

Length of wear can last up to ten days, however typical wear is 3-4 days. This will depend on daily lifestyle and lash care.